Driver for PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 - downloading and installing it

GW-USFang300 MAC1 is a Network Adapters device. The developer of this driver was PLANEX COMMUNICATIONS INC. The hardware id of this driver is USB/VID_2019&PID_4903&REV_0000&MI_01.

1. PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 - install the driver manually

1. You can download from the link below the driver setup file for the PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver. The archive contains version 1027.4.1120.2014 released on 2015-02-18 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

There is no digital signature available for this driver.
Driver file size: 1533009 bytes (1.46 MB)
This driver was installed by many users and received an average rating of 3.7 stars out of 51862 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. How to use DriverMax to install PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.