Driver for PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 - downloading and installing it

GW-USFang300 MAC1 is a Network Adapters hardware device. The developer of this driver was PLANEX COMMUNICATIONS INC. USB/VID_2019&PID_4903&MI_01 is the matching hardware id of this device.

1. PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 - install the driver manually

1. You can download from the link below the driver installer file for the PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver. The archive contains version 1026.12.0606.2014 dated 2014-06-25 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

This driver was rated with an average of 3.7 stars by 92093 users.

2. How to use DriverMax to install PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you locate the PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.