Driver for PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 - downloading and installing it

GW-USFang300 MAC1 is a Network Adapters device. This driver was developed by PLANEX COMMUNICATIONS INC. The hardware id of this driver is USB/VID_2019&PID_4903&MI_01.

1. Manually install PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver

1. Download the driver setup file for PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver from the location below. This is the download link for the driver version 1016.1.0223.2012 released on 2012-02-23.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, it is as simple as that.
8.  

This driver is digitally signed by the manufacturer.
Driver file size: 536221 bytes (523.65 KB)
This driver received an average rating of 5 stars out of 85340 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to install PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver using DriverMax

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.