Download and install PLANEX COMMUNICATIONS INC GW-USFang300 MAC0 driver

GW-USFang300 MAC0 is a Network Adapters hardware device. The Windows version of this driver was developed by PLANEX COMMUNICATIONS INC. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_2019&PID_4903&MI_00.

1. How to manually install PLANEX COMMUNICATIONS INC GW-USFang300 MAC0 driver

1. Download the setup file for PLANEX COMMUNICATIONS INC GW-USFang300 MAC0 driver from the link below. This is the download link for the driver version 1026.4.1023.2013 released on 2013-11-13.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
The file size of this driver is 1310068 bytes (1.25 MB)
This driver received an average rating of 5 stars out of 86298 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install PLANEX COMMUNICATIONS INC GW-USFang300 MAC0 driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Search the list until you find the PLANEX COMMUNICATIONS INC GW-USFang300 MAC0 driver. Click the Update button.
4.  
5. Finished installing the driver!
6.