Fresco Logic Fresco Logic xHCI USB3 Hub - two ways of downloading and installing the driver

Fresco Logic xHCI USB3 Hub is a USB Universal Serial Bus hardware device. The developer of this driver was Fresco Logic. In order to make sure you are downloading the exact right driver the hardware id is FLUSB_06531025/Class_09.

1. Fresco Logic Fresco Logic xHCI USB3 Hub - install the driver manually

1. You can download from the link below the driver installer file for the Fresco Logic Fresco Logic xHCI USB3 Hub driver. The archive contains version 3.3.44.0 released on 2011-08-10 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver was not digitally signed.

This driver was rated with an average of 3.7 stars by 63591 users.

2. Installing the Fresco Logic Fresco Logic xHCI USB3 Hub driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's see!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Fresco Logic Fresco Logic xHCI USB3 Hub driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.