Emulex Emulex OneConnect OCm11102-N-HDS, NIC - two ways of downloading and installing the driver

Emulex OneConnect OCm11102-N-HDS, NIC is a Network Adapters hardware device. The Windows version of this driver was developed by Emulex. PCI/VEN_19A2&DEV_0718&SUBSYS_E73410DF is the matching hardware id of this device.

1. Emulex Emulex OneConnect OCm11102-N-HDS, NIC driver - how to install it manually

1. You can download from the link below the driver installer file for the Emulex Emulex OneConnect OCm11102-N-HDS, NIC driver. The archive contains version 4.2.390.6 dated 2012-10-25 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

Emulex applied a digital signature to this driver.
The file size of this driver is 422524 bytes (412.62 KB)
This driver was rated with an average of 4.3 stars by 55312 users.
This driver was released for the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Using DriverMax to install Emulex Emulex OneConnect OCm11102-N-HDS, NIC driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Emulex Emulex OneConnect OCm11102-N-HDS, NIC driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.