Emulex Emulex OneConnect OCm10102-N-FTS, NIC/TOE - two ways of downloading and installing the driver

Emulex OneConnect OCm10102-N-FTS, NIC/TOE is a Network Adapters hardware device. This driver was developed by Emulex. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_19A2&DEV_0700&SUBSYS_117E1734.

1. Emulex Emulex OneConnect OCm10102-N-FTS, NIC/TOE driver - how to install it manually

1. You can download from the link below the driver setup file for the Emulex Emulex OneConnect OCm10102-N-FTS, NIC/TOE driver. The archive contains version 10.0.718.26 dated 2014-01-02 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is digitally signed by the manufacturer.
File size of the driver: 644257 bytes (629.16 KB)
Driver rating 4.9 stars out of 31058 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install Emulex Emulex OneConnect OCm10102-N-FTS, NIC/TOE driver

The advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Emulex Emulex OneConnect OCm10102-N-FTS, NIC/TOE driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.