Emulex Emulex OneConnect OCl11102-LOM, NIC/TOE how to download and install the driver

Emulex OneConnect OCl11102-LOM, NIC/TOE is a Network Adapters hardware device. The developer of this driver was Emulex. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_19A2&DEV_0710&SUBSYS_11C21734.

1. Manually install Emulex Emulex OneConnect OCl11102-LOM, NIC/TOE driver

1. Download the driver setup file for Emulex Emulex OneConnect OCl11102-LOM, NIC/TOE driver from the location below. This download link is for the driver version 4.2.390.6 dated 2012-10-25.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the updated driver, it is as simple as that.
8.  

Emulex applied a digital signature to this driver.
Driver file size: 422524 bytes (412.62 KB)
Driver rating 4.2 stars out of 45285 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to install Emulex Emulex OneConnect OCl11102-LOM, NIC/TOE driver using DriverMax

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Search the list until you locate the Emulex Emulex OneConnect OCl11102-LOM, NIC/TOE driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.