Download and install Emulex Emulex OneConnect OCl11102-F4-X, NIC/TOE driver

Emulex OneConnect OCl11102-F4-X, NIC/TOE is a Network Adapters hardware device. The developer of this driver was Emulex. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_19A2&DEV_0710&SUBSYS_E70E10DF.

1. How to manually install Emulex Emulex OneConnect OCl11102-F4-X, NIC/TOE driver

1. You can download from the link below the driver setup file for the Emulex Emulex OneConnect OCl11102-F4-X, NIC/TOE driver. The archive contains version 4.1.370.0 dated 2012-02-06 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

Emulex applied a digital signature to this driver.
File size of the driver: 405002 bytes (395.51 KB)
This driver received an average rating of 4 stars out of 29130 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Installing the Emulex Emulex OneConnect OCl11102-F4-X, NIC/TOE driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's see!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Emulex Emulex OneConnect OCl11102-F4-X, NIC/TOE driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.