Emulex Emulex OneConnect OCem10102-I-S, NIC/TOE - two ways of downloading and installing the driver

Emulex OneConnect OCem10102-I-S, NIC/TOE is a Network Adapters hardware device. This driver was developed by Emulex. The hardware id of this driver is PCI/VEN_19A2&DEV_0700&SUBSYS_E6AE10DF.

1. Emulex Emulex OneConnect OCem10102-I-S, NIC/TOE - install the driver manually

1. Download the driver setup file for Emulex Emulex OneConnect OCem10102-I-S, NIC/TOE driver from the link below. This download link is for the driver version 10.5.121.7 dated 2015-05-30.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

Emulex applied a digital signature to this driver.
The file size of this driver is 573229 bytes (559.79 KB)
This driver received an average rating of 4 stars out of 14716 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 7 64 bits

2. Installing the Emulex Emulex OneConnect OCem10102-I-S, NIC/TOE driver using DriverMax: the easy way

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the Emulex Emulex OneConnect OCem10102-I-S, NIC/TOE driver. Click on Update.
4.  
5. Finished installing the driver!
6.