Emulex Emulex OneConnect OCe10101-I-S, NIC/TOE - two ways of downloading and installing the driver

Emulex OneConnect OCe10101-I-S, NIC/TOE is a Network Adapters hardware device. This Windows driver was developed by Emulex. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_19A2&DEV_0700&SUBSYS_E6A010DF.

1. Install Emulex Emulex OneConnect OCe10101-I-S, NIC/TOE driver manually

1. Download the driver setup file for Emulex Emulex OneConnect OCe10101-I-S, NIC/TOE driver from the location below. This download link is for the driver version 10.5.121.7 dated 2015-05-30.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your UAC (User Access Control) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the new driver, as you can see it was quite smple.
8.  

Emulex applied a digital signature to this driver.
Driver file size: 573229 bytes (559.79 KB)
This driver was installed by many users and received an average rating of 4.4 stars out of 14695 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 64 bits

2. The easy way: using DriverMax to install Emulex Emulex OneConnect OCe10101-I-S, NIC/TOE driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the Emulex Emulex OneConnect OCe10101-I-S, NIC/TOE driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.