Driver for Realtek ELECOM DST-WCC01 - downloading and installing it

ELECOM DST-WCC01 is a Network Adapters device. The developer of this driver was Realtek. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_056E&PID_9013&REV_3100.

1. Realtek ELECOM DST-WCC01 driver - how to install it manually

1. Download the setup file for Realtek ELECOM DST-WCC01 driver from the location below. This is the download link for the driver version 11.03.20.1001 released on 2021-10-01.
2.  
3. Run the driver setup file from a Windows account with administrative rights. If your User Access Control Service (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

Realtek applied a digital signature to this driver.
Size of this driver: 621558 bytes (606.99 KB)
This driver was installed by many users and received an average rating of 4.5 stars out of 71615 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to install Realtek ELECOM DST-WCC01 driver using DriverMax

The advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Search the list until you find the Realtek ELECOM DST-WCC01 driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.