EETI EETI Touch Digitizer- SS - two ways of downloading and installing the driver

EETI Touch Digitizer- SS is a USB human interface device class device. The Windows version of this driver was developed by EETI. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_0EEF&PID_A822.

1. EETI EETI Touch Digitizer- SS - install the driver manually

1. Download the driver setup file for EETI EETI Touch Digitizer- SS driver from the link below. This is the download link for the driver version 1.0.0.3 dated 2013-05-12.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, it is as simple as that.
8.  

This driver is not digitally signed.

Driver rating 3.7 stars out of 94909 votes.

2. Using DriverMax to install EETI EETI Touch Digitizer- SS driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the EETI EETI Touch Digitizer- SS driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.