EETI EETI Touch Digitizer- SS - two ways of downloading and installing the driver

EETI Touch Digitizer- SS is a USB human interface device class device. This Windows driver was developed by EETI. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_0EEF&PID_7969.

1. Manually install EETI EETI Touch Digitizer- SS driver

1. You can download from the link below the driver setup file for the EETI EETI Touch Digitizer- SS driver. The archive contains version 1.0.0.3 dated 2013-05-12 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

This driver was installed by many users and received an average rating of 3.2 stars out of 63947 votes.

2. Installing the EETI EETI Touch Digitizer- SS driver using DriverMax: the easy way

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the EETI EETI Touch Digitizer- SS driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.