Driver for Realtek EDC-G01 - downloading and installing it

EDC-G01 is a Network Adapters device. The Windows version of this driver was developed by Realtek. The hardware id of this driver is USB/VID_056E&PID_4013&REV_3105.

1. How to manually install Realtek EDC-G01 driver

1. You can download from the link below the driver setup file for the Realtek EDC-G01 driver. The archive contains version 10.34.0603.2019 dated 2019-06-03 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is digitally signed.
Size of this driver: 322995 bytes (315.42 KB)
Driver rating 4.7 stars out of 81896 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to install Realtek EDC-G01 driver using DriverMax

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Realtek EDC-G01 driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.