Download and install DisplayLink DisplayLink Network Adapter NCM driver

DisplayLink Network Adapter NCM is a Network Adapters hardware device. This driver was developed by DisplayLink. The hardware id of this driver is USB/VID_17E9&PID_C05B&MI_05.

1. Manually install DisplayLink DisplayLink Network Adapter NCM driver

1. You can download from the link below the driver setup file for the DisplayLink DisplayLink Network Adapter NCM driver. The archive contains version 10.2.6854.0 dated 2022-03-08 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

DisplayLink applied a digital signature to this driver.
Size of this driver: 66057 bytes (64.51 KB)
This driver received an average rating of 4.4 stars out of 47382 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. Using DriverMax to install DisplayLink DisplayLink Network Adapter NCM driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the DisplayLink DisplayLink Network Adapter NCM driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.