DisplayLink DisplayLink Network Adapter NCM - two ways of downloading and installing the driver

DisplayLink Network Adapter NCM is a Network Adapters hardware device. This driver was developed by DisplayLink. USB/VID_17E9&PID_804A&MI_05 is the matching hardware id of this device.

1. How to manually install DisplayLink DisplayLink Network Adapter NCM driver

1. Download the setup file for DisplayLink DisplayLink Network Adapter NCM driver from the location below. This download link is for the driver version 8.4.2815.0 released on 2017-11-14.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be pretty straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the updated driver, it is as simple as that.
8.  

This driver is digitally signed.
Driver file size: 62856 bytes (61.38 KB)
This driver was rated with an average of 4.2 stars by 86709 users.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. How to use DriverMax to install DisplayLink DisplayLink Network Adapter NCM driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the DisplayLink DisplayLink Network Adapter NCM driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.