DisplayLink DisplayLink Network Adapter NCM how to download and install the driver

DisplayLink Network Adapter NCM is a Network Adapters hardware device. This driver was developed by DisplayLink. USB/VID_17E9&PID_6028&MI_05 is the matching hardware id of this device.

1. DisplayLink DisplayLink Network Adapter NCM driver - how to install it manually

1. Download the setup file for DisplayLink DisplayLink Network Adapter NCM driver from the link below. This is the download link for the driver version 10.1.2874.0 released on 2021-08-06.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

DisplayLink applied a digital signature to this driver.
File size of the driver: 68415 bytes (66.81 KB)
This driver received an average rating of 4.3 stars out of 23755 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install DisplayLink DisplayLink Network Adapter NCM driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the DisplayLink DisplayLink Network Adapter NCM driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.