DisplayLink DisplayLink Network Adapter NCM how to download and install the driver

DisplayLink Network Adapter NCM is a Network Adapters hardware device. This Windows driver was developed by DisplayLink. The hardware id of this driver is USB/VID_17E9&PID_43B5&MI_05; this string has to match your hardware.

1. Manually install DisplayLink DisplayLink Network Adapter NCM driver

1. Download the driver setup file for DisplayLink DisplayLink Network Adapter NCM driver from the location below. This is the download link for the driver version 8.5.2891.0 dated 2018-02-15.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the updated driver, as you can see it was quite smple.
8.  

DisplayLink applied a digital signature to this driver.
Size of this driver: 69939 bytes (68.30 KB)
Driver rating 4.7 stars out of 96160 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install DisplayLink DisplayLink Network Adapter NCM driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the DisplayLink DisplayLink Network Adapter NCM driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.