Driver for DisplayLink DisplayLink Network Adapter NCM - downloading and installing it

DisplayLink Network Adapter NCM is a Network Adapters device. The Windows version of this driver was developed by DisplayLink. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_17E9&PID_43B1&MI_05.

1. Install DisplayLink DisplayLink Network Adapter NCM driver manually

1. Download the setup file for DisplayLink DisplayLink Network Adapter NCM driver from the link below. This download link is for the driver version 10.2.6854.0 dated 2022-03-08.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

DisplayLink applied a digital signature to this driver.
File size of the driver: 66057 bytes (64.51 KB)
This driver received an average rating of 4.6 stars out of 49669 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. Using DriverMax to install DisplayLink DisplayLink Network Adapter NCM driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the DisplayLink DisplayLink Network Adapter NCM driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.