Driver for DisplayLink DisplayLink Network Adapter NCM - downloading and installing it

DisplayLink Network Adapter NCM is a Network Adapters device. The developer of this driver was DisplayLink. The hardware id of this driver is USB/VID_17E9&PID_4361&MI_05; this string has to match your hardware.

1. Manually install DisplayLink DisplayLink Network Adapter NCM driver

1. Download the setup file for DisplayLink DisplayLink Network Adapter NCM driver from the location below. This is the download link for the driver version 10.2.6854.0 released on 2022-03-08.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

DisplayLink applied a digital signature to this driver.
Download size of the driver: 66057 bytes (64.51 KB)
Driver rating 4.8 stars out of 49197 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. Installing the DisplayLink DisplayLink Network Adapter NCM driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the DisplayLink DisplayLink Network Adapter NCM driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.