DisplayLink DisplayLink Network Adapter NCM - two ways of downloading and installing the driver

DisplayLink Network Adapter NCM is a Network Adapters hardware device. This driver was developed by DisplayLink. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_17E9&PID_4358&MI_05.

1. DisplayLink DisplayLink Network Adapter NCM - install the driver manually

1. Download the driver setup file for DisplayLink DisplayLink Network Adapter NCM driver from the link below. This is the download link for the driver version 8.5.2891.0 dated 2018-02-15.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is digitally signed by DisplayLink.
File size of the driver: 69939 bytes (68.30 KB)
Driver rating 5 stars out of 95715 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Using DriverMax to install DisplayLink DisplayLink Network Adapter NCM driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's see!

1. Open DriverMax and click on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you locate the DisplayLink DisplayLink Network Adapter NCM driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.