DisplayLink DisplayLink Network Adapter NCM driver download and installation

DisplayLink Network Adapter NCM is a Network Adapters hardware device. The developer of this driver was DisplayLink. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_17E9&PID_4350&MI_05.

1. Manually install DisplayLink DisplayLink Network Adapter NCM driver

1. Download the setup file for DisplayLink DisplayLink Network Adapter NCM driver from the link below. This is the download link for the driver version 10.2.6854.0 dated 2022-03-08.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is digitally signed by DisplayLink.
Size of this driver: 66057 bytes (64.51 KB)
This driver was rated with an average of 4.8 stars by 49345 users.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. How to use DriverMax to install DisplayLink DisplayLink Network Adapter NCM driver

The advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the DisplayLink DisplayLink Network Adapter NCM driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.