Driver for DisplayLink DisplayLink Network Adapter NCM - downloading and installing it

DisplayLink Network Adapter NCM is a Network Adapters hardware device. The developer of this driver was DisplayLink. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_17E9&PID_434D&MI_05.

1. DisplayLink DisplayLink Network Adapter NCM driver - how to install it manually

1. Download the driver setup file for DisplayLink DisplayLink Network Adapter NCM driver from the link below. This download link is for the driver version 8.3.1728.0 dated 2017-06-27.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is digitally signed by DisplayLink.
Driver file size: 69436 bytes (67.81 KB)
This driver was rated with an average of 5 stars by 42442 users.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install DisplayLink DisplayLink Network Adapter NCM driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the DisplayLink DisplayLink Network Adapter NCM driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.