Driver for Dell Dell ControlVault w/ Fingerprint Swipe Sensor - downloading and installing it

Dell ControlVault w/ Fingerprint Swipe Sensor is a CVAULT hardware device. This Windows driver was developed by Dell. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_0A5C&PID_5801&REV_0102&MI_00.

1. How to manually install Dell Dell ControlVault w/ Fingerprint Swipe Sensor driver

1. You can download from the link below the driver installer file for the Dell Dell ControlVault w/ Fingerprint Swipe Sensor driver. The archive contains version 6.1.7600.16385 dated 2014-05-06 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is not digitally signed.

Driver rating 4 stars out of 45155 votes.

2. Using DriverMax to install Dell Dell ControlVault w/ Fingerprint Swipe Sensor driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's see!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Dell Dell ControlVault w/ Fingerprint Swipe Sensor driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.