Dell Dell ControlVault w/ Fingerprint Swipe Sensor driver download and installation

Dell ControlVault w/ Fingerprint Swipe Sensor is a CVAULT hardware device. This Windows driver was developed by Dell. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_0A5C&PID_5801&REV_0102.

1. How to manually install Dell Dell ControlVault w/ Fingerprint Swipe Sensor driver

1. You can download from the link below the driver installer file for the Dell Dell ControlVault w/ Fingerprint Swipe Sensor driver. The archive contains version 6.1.7600.16385 dated 2012-10-04 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

Driver rating 3.3 stars out of 55053 votes.

2. The easy way: using DriverMax to install Dell Dell ControlVault w/ Fingerprint Swipe Sensor driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's see!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Dell Dell ControlVault w/ Fingerprint Swipe Sensor driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.