Allied Telesis K.K. CG-WLUSB300GNM how to download and install the driver

CG-WLUSB300GNM is a Network Adapters hardware device. The Windows version of this driver was developed by Allied Telesis K.K.. USB/VID_07AA&PID_0042 is the matching hardware id of this device.

1. Install Allied Telesis K.K. CG-WLUSB300GNM driver manually

1. Download the driver setup file for Allied Telesis K.K. CG-WLUSB300GNM driver from the location below. This download link is for the driver version 5.01.24.0000 dated 2015-09-21.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
The file size of this driver is 1336576 bytes (1.27 MB)
This driver received an average rating of 4.2 stars out of 3404 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. How to install Allied Telesis K.K. CG-WLUSB300GNM driver using DriverMax

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Allied Telesis K.K. CG-WLUSB300GNM driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.