Driver for Brother Brother DCP-J972N LAN - downloading and installing it

Brother DCP-J972N LAN is a Imaging Devices hardware device. The Windows version of this driver was developed by Brother. In order to make sure you are downloading the exact right driver the hardware id is VID_04F9&PID_0406&NETSCN.

1. Install Brother Brother DCP-J972N LAN driver manually

1. Download the setup file for Brother Brother DCP-J972N LAN driver from the link below. This download link is for the driver version 1.0.36.1 dated 2019-02-07.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

This driver received an average rating of 3.3 stars out of 11269 votes.

2. How to install Brother Brother DCP-J972N LAN driver using DriverMax

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's see!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Brother Brother DCP-J972N LAN driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.