Blackmagic Design Blackmagic GPI and Tally Interface - two ways of downloading and installing the driver

Blackmagic GPI and Tally Interface is a MEDIA device. This Windows driver was developed by Blackmagic Design. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_1EDB&PID_BD50.

1. How to manually install Blackmagic Design Blackmagic GPI and Tally Interface driver

1. Download the driver setup file for Blackmagic Design Blackmagic GPI and Tally Interface driver from the link below. This is the download link for the driver version 9.2.1.0 dated 2023-09-20.
2.  
3. Run the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

There is no digital signature available for this driver.

This driver received an average rating of 3.4 stars out of 95075 votes.

2. Installing the Blackmagic Design Blackmagic GPI and Tally Interface driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the Blackmagic Design Blackmagic GPI and Tally Interface driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.