Driver for Atmel Atmel Touchscreen Digitizer - downloading and installing it

Atmel Touchscreen Digitizer is a USB human interface device class device. The Windows version of this driver was developed by Atmel. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_03EB&PID_8A06&REV_*&MI_00.

1. Install Atmel Atmel Touchscreen Digitizer driver manually

1. Download the setup file for Atmel Atmel Touchscreen Digitizer driver from the link below. This is the download link for the driver version 1.8.2.0 released on 2015-12-15.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, it is as simple as that.
8.  

This driver is digitally signed.
File size of the driver: 15060 bytes (14.71 KB)
Driver rating 4 stars out of 43529 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 7 32 bits
• This driver works on Windows 7 64 bits

2. Installing the Atmel Atmel Touchscreen Digitizer driver using DriverMax: the easy way

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's see!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Search the list until you locate the Atmel Atmel Touchscreen Digitizer driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.