Marvell Allied Telesis AT-DNC10 Series Ethernet driver download and installation

Allied Telesis AT-DNC10 Series Ethernet is a Network Adapters hardware device. This Windows driver was developed by Marvell. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1D6A&DEV_00B1&SUBSYS_29931259&REV_02.

1. Marvell Allied Telesis AT-DNC10 Series Ethernet - install the driver manually

1. Download the setup file for Marvell Allied Telesis AT-DNC10 Series Ethernet driver from the link below. This download link is for the driver version 3.1.8.0 dated 2023-04-17.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the fresh driver, as you can see it was quite smple.
8.  

There is no digital signature available for this driver.

This driver received an average rating of 3.7 stars out of 76192 votes.

2. Using DriverMax to install Marvell Allied Telesis AT-DNC10 Series Ethernet driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's take a look!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the Marvell Allied Telesis AT-DNC10 Series Ethernet driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.