Marvell Allied Telesis AT-DNC10 Series Ethernet - two ways of downloading and installing the driver

Allied Telesis AT-DNC10 Series Ethernet is a Network Adapters hardware device. The developer of this driver was Marvell. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1D6A&DEV_00B1&SUBSYS_29921259&REV_02.

1. Marvell Allied Telesis AT-DNC10 Series Ethernet driver - how to install it manually

1. Download the driver setup file for Marvell Allied Telesis AT-DNC10 Series Ethernet driver from the location below. This download link is for the driver version 2.2.3.0 dated 2021-02-12.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be pretty straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is digitally signed by the manufacturer.
Download size of the driver: 132058 bytes (128.96 KB)
This driver was installed by many users and received an average rating of 4 stars out of 75129 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Installing the Marvell Allied Telesis AT-DNC10 Series Ethernet driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's see!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Marvell Allied Telesis AT-DNC10 Series Ethernet driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.