Marvell Allied Telesis AT-2916T how to download and install the driver

Allied Telesis AT-2916T is a Network Adapters hardware device. This driver was developed by Marvell. The hardware id of this driver is PCI/VEN_1148&DEV_4320&SUBSYS_29161259.

1. Install Marvell Allied Telesis AT-2916T driver manually

1. Download the driver setup file for Marvell Allied Telesis AT-2916T driver from the location below. This is the download link for the driver version 12.10.14.3 dated 2013-01-08.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the fresh driver, as you can see it was quite smple.
8.  

Marvell applied a digital signature to this driver.
Download size of the driver: 306984 bytes (299.79 KB)
This driver received an average rating of 4.7 stars out of 54518 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 64 bits

2. How to use DriverMax to install Marvell Allied Telesis AT-2916T driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Marvell Allied Telesis AT-2916T driver. Click the Update button.
4.  
5. Finished installing the driver!
6.