Driver for Hamrick Software Agfa SnapScan e25 - downloading and installing it

Agfa SnapScan e25 is a Imaging Devices hardware device. This Windows driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_06bd&Pid_2095.

1. Manually install Hamrick Software Agfa SnapScan e25 driver

1. Download the setup file for Hamrick Software Agfa SnapScan e25 driver from the location below. This download link is for the driver version 1.0.0.136 dated 2006-08-21.
2.  
3. Run the driver installation file from a Windows account with administrative rights. If your UAC (User Access Control) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

This driver is not digitally signed.

This driver received an average rating of 3.6 stars out of 44052 votes.

2. Using DriverMax to install Hamrick Software Agfa SnapScan e25 driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Hamrick Software Agfa SnapScan e25 driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.