Actiontec Actiontec ScreenBeam USB Transmitter - two ways of downloading and installing the driver

Actiontec ScreenBeam USB Transmitter is a Network Adapters device. The Windows version of this driver was developed by Actiontec. The hardware id of this driver is USB/VID_1668&PID_8102; this string has to match your hardware.

1. Actiontec Actiontec ScreenBeam USB Transmitter - install the driver manually

1. You can download from the link below the driver setup file for the Actiontec Actiontec ScreenBeam USB Transmitter driver. The archive contains version 1021.11.0724.2013 dated 2013-07-24 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is digitally signed by the manufacturer.
Size of this driver: 813567 bytes (794.50 KB)
This driver was rated with an average of 4.1 stars by 36137 users.
This driver was released for the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install Actiontec Actiontec ScreenBeam USB Transmitter driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Actiontec Actiontec ScreenBeam USB Transmitter driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.