Blackmagic Design ATEM Mini Extreme - two ways of downloading and installing the driver

ATEM Mini Extreme is a MEDIA hardware device. The developer of this driver was Blackmagic Design. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_1EDB&PID_BE7C&MI_00.

1. How to manually install Blackmagic Design ATEM Mini Extreme driver

1. You can download from the link below the driver installer file for the Blackmagic Design ATEM Mini Extreme driver. The archive contains version 9.2.1.0 released on 2023-09-20 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

There is no digital signature available for this driver.

Driver rating 3.2 stars out of 94857 votes.

2. The easy way: using DriverMax to install Blackmagic Design ATEM Mini Extreme driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Blackmagic Design ATEM Mini Extreme driver. Click on Update.
4.  
5. Finished installing the driver!
6.