Download and install Blackmagic Design ATEM Camera Converter driver

ATEM Camera Converter is a MEDIA device. This Windows driver was developed by Blackmagic Design. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_1EDB&PID_BD54.

1. Manually install Blackmagic Design ATEM Camera Converter driver

1. Download the setup file for Blackmagic Design ATEM Camera Converter driver from the location below. This is the download link for the driver version 7.5.0.0 dated 2020-07-09.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your UAC (User Access Control) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

Driver rating 3.8 stars out of 17879 votes.

2. How to install Blackmagic Design ATEM Camera Converter driver using DriverMax

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Search the list until you find the Blackmagic Design ATEM Camera Converter driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.