3M devices 3M MicroTouch Serial Sensor - two ways of downloading and installing the driver

3M MicroTouch Serial Sensor is a USB human interface device class device. This driver was developed by 3M devices. The hardware id of this driver is PnP/TwTouch.

1. Install 3M devices 3M MicroTouch Serial Sensor driver manually

1. Download the setup file for 3M devices 3M MicroTouch Serial Sensor driver from the link below. This is the download link for the driver version 7.13.15.0 released on 2013-09-27.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the updated driver, it is as simple as that.
8.  

This driver was not digitally signed.

This driver was installed by many users and received an average rating of 3.7 stars out of 22254 votes.

2. How to use DriverMax to install 3M devices 3M MicroTouch Serial Sensor driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's take a look!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the 3M devices 3M MicroTouch Serial Sensor driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.