3Dconnexion 3Dconnexion Apollo Bluetooth driver download and installation

3Dconnexion Apollo Bluetooth is a USB human interface device class hardware device. This Windows driver was developed by 3Dconnexion. In order to make sure you are downloading the exact right driver the hardware id is HID/{00001124-0000-1000-8000-00805f9b34fb}_VID&0000256f_PID&c62d.

1. Install 3Dconnexion 3Dconnexion Apollo Bluetooth driver manually

1. You can download from the link below the driver setup file for the 3Dconnexion 3Dconnexion Apollo Bluetooth driver. The archive contains version 1.3.0.10403 released on 2014-06-06 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver was not digitally signed.

This driver received an average rating of 3.1 stars out of 31097 votes.

2. How to use DriverMax to install 3Dconnexion 3Dconnexion Apollo Bluetooth driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the 3Dconnexion 3Dconnexion Apollo Bluetooth driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.